My toddler often asks to play "The Unicorn Game" (actually Vast: The Crystal Caverns & Fearsome Foes expansion), which for her simply means lining up cave tiles.
So I'm going to make a set just for her using the @okumarts Adorkable Dungeon Tiles.
https://www.patreon.com/okumarts/posts
So I'm going to make a set just for her using the @okumarts Adorkable Dungeon Tiles.
https://www.patreon.com/okumarts/posts
Right. I stuck all the Adorkable Dungeon Tiles into 5mm black foam board. Some of them got glued on a bit wonky, but overall those look pretty good.
I'll ask my kid which people (Adorkable Dungeon Heroes) she wants cut out this afternoon.
I'll ask my kid which people (Adorkable Dungeon Heroes) she wants cut out this afternoon.
The Adorkable Dungeon monsters (goblins, hobgoblins, and an ogre) are cute but might be too scary for her. I'll ask and see.
Anyone know if there's a unicorn paper mini out there somewhere? Cause that'd be awesome.
Anyone know if there's a unicorn paper mini out there somewhere? Cause that'd be awesome.
My kid said we needed a dragon (as well as a knight, a thief, goblins, a unicorn, and a ghost) for her game.
I showed her @TrashMobMinis 2.5D dragon kits and all got the seal of approval, except for the red and skeleton dragon. They were too scary.
https://www.drivethrurpg.com/m/product/191449
I showed her @TrashMobMinis 2.5D dragon kits and all got the seal of approval, except for the red and skeleton dragon. They were too scary.
https://www.drivethrurpg.com/m/product/191449
Bit of a mistake to try to cut & assemble these @TrashMobMinis while my kid was awake.
Yes, these are for her, but she's at the age where she wants to help. Which in this case means insisting she use my X-Acto knife, which is simply NOT happening.
Yes, these are for her, but she's at the age where she wants to help. Which in this case means insisting she use my X-Acto knife, which is simply NOT happening.
My kid also chose this Cleric paper mini from Heros Pack 07 as her Knight "because it looks like Anna (from Frozen)".
https://www.drivethrurpg.com/m/product/251264
https://www.drivethrurpg.com/m/product/251264
And the knight & dragon are done.
My process was:
1. Rough trim color prints.
2. Glue to black construction paper.
3. Rough trim again.
4. Fold and glue.
5. Trim.
6. Edge with black COPIC marker.
6b. Assemble dragon.
7. Stick to 5mm foam board bases.
8. Edge bases.
BOOM.
My process was:
1. Rough trim color prints.
2. Glue to black construction paper.
3. Rough trim again.
4. Fold and glue.
5. Trim.
6. Edge with black COPIC marker.
6b. Assemble dragon.
7. Stick to 5mm foam board bases.
8. Edge bases.

